Local properties of bauxite residue filter cakes

The research article 'Local properties of filter cakes formed from pH-adjusted bauxite residue slurries' has been published in Elsevier journal Separation and Purification Technology.

Abstract

Solid-liquid separation of bauxite residue is a topical issue in the alumina industry, not least due to the great quantity and problematic properties of this highly alkaline residue. The objective of this contribution is to provide deeper knowledge about the solid–liquid separation of pH-adjusted (pH 11) bauxite residue by investigating the local filtration properties of filter cakes produced with a piston press. Two bauxite residue samples having different particle size distribution were investigated. Measured local data of the hydrostatic pressure and solidosity was used together with flow rate data to calculate local specific filtration resistance as well as compressibility data. For the investigated pressure range (0.2–2 MPa) it was found that the residue formed slightly/moderately compressible filter cakes with a specific cake resistance between 5·1011 to 1.5·1012 m/kg. The sodium recovery and final cake solidosity were strongly dependent on the applied pressure, but only to a minor extent on the particle size reduction obtained by the applied mechanical treatment. The filter cakes formed from the mechanically treated samples did, however, display a somewhat higher pressure dependence for the local specific filtration resistance compared to the non-ground samples.

Read the full text on ScienceDirect.